Skip to content
Home » Sway Bar Links For 6 Inch Lift Silverado

Sway Bar Links For 6 Inch Lift Silverado

When it comes to ensuring a smooth and controlled ride, the sway bar plays a crucial role in a vehicle’s suspension system. However, wear and tear are inevitable, and knowing how to replace sway bar links is an essential skill for any car enthusiast. In this comprehensive guide, we’ll walk you through the process step-by-step, providing detailed instructions for a seamless replacement.

Tools Required for the Job

Before diving into the replacement process, gather the necessary tools:

  • 14-millimeter socket
  • 16-millimeter wrench
  • Antiseize spray or brush
  • Replacement sway bar links

Removing the Old Sway Bar Links

Step 1: Secure the Top

Begin by using a 16-millimeter wrench to secure the top of the sway bar link in place.

Step 2: Remove the Bottom Bolt

Using a 14-millimeter socket, carefully undo the bottom bolt, which serves as the main bolt for the sway bar link. Remove the bushings, spacer, and washers associated with the old link.

Step 3: Repeat for the Other Side

Once the first side is disassembled, repeat the same procedure for the other side, removing the old sway bar link components.

Installing the New Sway Bar Links

Step 4: Prepare the New Sway Bar Link

With the new sway bar link disassembled, leave the bottom washer and rubber bushing in place. Slide this assembly through the control arm.

Step 5: Position the Rubber Bushings

Place the other rubber bushing facing downward, ensuring the lip is positioned at the bottom while it remains flat on the top. Follow this with a washer.

Step 6: Apply Antiseize

Before proceeding further, apply antiseize spray or brush to prevent future seizing of the sleeve. Ensure proper application for smoother functionality.

Step 7: Assemble the Top Section

Continue assembling the top section by adding the top washer and bushing, aligning the lip facing upward.

Step 8: Secure with the Nut

Finally, secure the assembly with the nut. Note the nut’s design—ensure the square, locking side faces the top for proper installation.

Step 9: Tighten the Sway Bar Link

Using your tools, tighten the sway bar link. Monitor the bushings’ compression; stop tightening once you observe slight compression to avoid cracks or premature wear.


Replacing sway bar links is a manageable task that significantly contributes to your vehicle’s stability and ride quality. By following these steps and paying attention to details, you can enhance your driving experience and maintain your car’s suspension system effectively.

Always remember to prioritize safety during any maintenance task and double-check your work to ensure everything is securely fastened.